Attachment instructions
Make sure you know how to attach your device correctly. If not, just follow the instructions below.
1. Recommended tag placement.
No placement photo is available for this machine. Please attach the tag in the most appropriate location.
General guidelines:
- Identify the part of the machine with the highest level of vibration.
- Ensure the tag is not blocked or covered.
- Ensure the tag is facing upwards or mounted at a maximum angle of 90 degrees.
- Ensure the mounting surface is flat.
If you need help or have any questions, please contact us at support@taggr.se. Otherwise, continue with the remaining installation steps.
2. Clean the surface thoroughly.
Ensure the surface is free from dust, dirt, grease, and moisture. Always clean the surface using a cleaning solution and a clean cloth.
3. Remove the protective film.
Carefully peel off the protective film from the adhesive tape on the bottom of the tag. Wait 1 minute before attaching the tag for optimal adhesion.
4. Attach the tag to the designated location.
Position the tag at the recommended location and press firmly. The corner holes are not intended for mounting or fastening. Apply firm, even pressure over the tag for at least 5 seconds to ensure proper adhesion.
5. Attach the bracket and secure it with screws (optional but recommended)
Place the bracket over the sensor and secure it with the screws. Ensure that the mounting location is suitable and will not damage the machine, including the fuel tank or other sensitive components. Also note that the screws may protrude from the underside and could cause damage if installed in an unsuitable location.